• Home
• Electrical safety
• Workplace health & safety
• Industrial relations
• Corporate information

• 1. Introduction
• 2. The Electrical Safety Act 2002
• 3. The Electrical Safety Regulation 2002
• 4. Risk management
• 5. Operating cranes and plant near overhead electric lines
  • 5.1 Scope
  • 5.2 Regulation requirement on exclusion zone for electric lines
  • 5.3 Exclusion zone
  • 5.4 Risk management process for a crane working near electric lines
  • 5.5 Working in the safety observer zone
• 6. Work near low voltage overhead electric lines
  • 6.1 Scope
  • 6.2 The no-touch and exclusion zones
  • 6.3 Hazard identification
  • 6.4 Risk assessment
  • 6.5 Examining the low voltage overhead line for visual defects
  • 6.6 Deciding on control measures
• 7. Clearing vegetation near overhead electric lines
• 8. Agricultural work near overhead electric lines
  • 8.1 Scope
  • 8.2 Regulation on exclusion zones
  • 8.3 Hazard identification
  • 8.4 Risk assessment
  • 8.5 Deciding on control measures
  • 8.6 Particular circumstances
• 9. Transportation of high loads near electric lines
  • 9.1 Scope
  • 9.2 Meaning of terms
  • 9.3 What is a high load?
  • 9.4 Legislative requirements
  • 9.5 Travel requirements
  • 9.6 Responsibilities
• 10. Repair of electrical equipment
• 11. Work near electrical hazards in buildings and near underground electrical cables
• Appendix A - Meaning of terms used in this code
• Appendix B - Exclusion zones in millimetres

More about working around electricity

	Print-friendly page
	Print full Working Near Exposed Live Parts Code of Practice (PDF, 239KB)

6. Work near low voltage overhead electric lines near buildings and structures

6.1 Scope
6.2 The no-touch and exclusion zones
6.3 Hazard identification
6.4 Risk assessment
6.5 Examining the low voltage
6.6 Deciding on control measures

Last updated July 16, 2009

Copyright | Disclaimer | Privacy | Access keys | Other languages

© The State of Queensland (Department of Justice and Attorney-General) 2009.

Queensland Government